Benchmark BW Series Manual

37
BW SERIES
1. Remove the spark plug cap.
2. Remove the spark plug with the spark plug wrench.
3. Visually inspect the spark plug. Replace with a new plug if the insulation is
cracked or chipped. Clean with a wire brush if the spark plug is reused.
4. Measure the spark plug gap with a feeler gauge. The normal value is:
0.7-0.8 mm (0.028- 0.031 in). Adjust the gap by carefully bending the
electrode.
5. Carefully reinstall the spark plug by hand, to avoid cross-threading. A new
spark plug should be tightened 1/2 turn with a spanner. A used spark plug
should be tightened 1/8 to 1/4 turn with spanner.
6. Reinstall the spark plug cap.
NOTE
 The spark plug must be securely tightened or it could cause the spark
plug to heat up, enough to damage the engine.
 Never use a spark plug with an improper heat range.
7.8 SPARK ARRESTER MAINTENANCE
1. After the engine has cooled down remove the bolts securing the mufer
cover to the mufer.
2. Use a brush to remove carbon deposits from the spark arrester.
7.9 FUEL FILTER MAINTENANCE
1. Remove the fuel cap and lter.
2. Clean the lter with solvent.
3. Wipe the lter.
4. Reinsert the lter.
a brush to remove carbon deposits from the
k arrester . If the spark arrester is wear,
ace it.
stall the spark arrester and muffle guard.
<<
ush to remove carbon deposits from the
rester . If the spark arrester is wear,
t.
l the spark arrester and muffle guard.
<<31>
1 2 3 4
osits from the
r is wear,
uffle guard.
<<31>>
m the
d.
8.7.3••••Wipe••the••filter••and••insert••it.
<<31>>
8.6.4)Reinstall the spark arrester and muffle guard.

Benchmark BW Series Specifications

General

Brand	Benchmark
Model	BW Series
Category	Pressure Washer
Language	English