40 Bend-Tech Dragon A150
Troubleshooting Guide
Laser
07
Laser Replacement
The Laser is a consumable and over time it can fail. If the Operator has determined the Laser
collar. The Laser will connect to the Control Box via a two prong plug. The type of plug will
depend on the age of the machine.
1. Loosen the set screw that secures the Laser to the Torch mounting collar. Depending on
2.
ties that secure the loom to the machine.
3. Unplug the Laser cord from its Control Box connection.
4. Plug in the new Laser.
5. Route the Laser cord in the same fashion the old Laser cord was routed, placing the cord
6. Place the Laser in its mount in the Torch mount collar. Secure with set screw.
To Next Page
Loading...
