55Bend-Tech Dragon A150
Troubleshooting Guide
X and Y Axis Maintenance
11
8. Tighten the Chuck securely onto the material
9. At the back of the Trolley, position the material so it is centered in the rear Chuck cover
opening.
10.
screws thread in through the bottom of the Trolley plate. Ensure the material remains in the
centered position.
11. Using two ¾ in wrenches, tighten Pillow block mounting bolts, then tighten another ¼ - ½
turn.
12. Pull the Y motor so the Y motor drive chain has appropriate tension. There should be
minimal slack. Ensure tension is not excessive. Using a ½ in. wrench, secure the Y motor
mounting bolts.
13.
secure the Chuck cover.
14. Remove the material from the machine.
To Next Page
Loading...
Need help?
General
