Autostacker™ Parking Lift 21 P/N 5900002 — Rev. D — August 2019
Anchor Bases to the Ground
Both Autostacker Bases have three holes in them for anchoring the base to the ground, with two holes
placed in the front of each Leg Assembly and one located in the back.
Tip If you prefer, you can defer anchoring the Autostacker Bases into place until later in
the installation. Simply return to this section when you are ready.
Before you anchor your Autostacker, make sure
the Leg Assemblies are correctly aligned.
⚠ CAUTION Poor alignment can affect how the Autostacker raises and lowers. Take the time
now, before you anchor the Autostacker in place, to make sure it is correctly
aligned.
To Next Page
Loading...
