Autostacker™ Parking Lift 63 P/N 5900002 — Rev. D — August 2019
10. Move the Control Stand out of the way, then drill two holes 3/8" wide by 4" (102 mm) deep in the
concrete floor at the locations you marked.
Go in straight; do not let the drill wobble. Use a carbide bit (conforming to the current ANSI
B212.15).
11. Remove all dust from the holes.
12. Use a wire brush, vacuum, hand pump, or compressed air. Do
not
ream the hole. Do
not
make
the hole any wider than the drill made it.
13. Move the Control Stand in place over the two holes, then insert an Anchor Bolt with a Washer into
each hole, tapping it down into the hole.
14. Wrench the Anchor Bolt clockwise to the recommended installation torque, 85-95 pound feet,
using a Torque Wrench.
To Next Page
Loading...
