8
SELECTION OF THE TYPE OF ENCODING (TO. GO/HAPPY VA)
VA series transmitters can operate in either HCS (Benincà Rolling-code) or ARC (Advanced
Rolling-code) mode. This allows you to use the transmitters on systems equipped with HCS
receivers. The transmitter comes with ARC mode factory setting.
To modify the code type:
- Press and keep simultaneously pressed keys T1 and T2.
- After approx. 3 seconds, the LED starts to flash, the number of flashes indicates the code cur-
rently set:
3 flashes and pause of 1 second, the transmitter is to be set up as ARC.
4 flashes and pause of 1 second, the transmitter is to be set up as ARC + HCS*.
2 flashes and pause of 1 second, the transmitter is to be set up as HCS.
- Keeping buttons T1-T2 pressed, after approx. 20 seconds, the LED switches on fixed for ap-
prox. 3s. Releasing the buttons during these 3s, the transmitter is configured with the net ope-
rating mode (mode 3 blink >> 4 blink >> 2 blink >> 3 blink >> 4 blink >> etc).
If buttons T1/T2 are released when the LED is not on with the light fixed, no configuration
change is made.
*In this mode, the keys on the left (T1 and T3) are coded ARC and those on the right (T2 and T4)
are coded HCS. This mode is only available for transmitters marked “128”.
T1
T2
T4
LED
SELECTION OF THE TYPE OF ENCODING (IRI.TX VA)
VA series transmitters can operate in either HCS (Benincà Rolling-code) or ARC (Advanced
Rolling-code) mode. This allows you to use the transmitters on systems equipped with HCS
receivers. The transmitter comes with ARC mode factory setting.
To modify the code type:
- Press and keep simultaneously pressed keys T1 and T2.
- After approx. 3 seconds, the LED starts to flash, the number of flashes indicates the code cur-
rently set:
3 flashes and pause of 1 second, the transmitter is to be set up as ARC.
4 flashes and pause of 1 second, the transmitter is to be set up as ARC + HCS*.
2 flashes and pause of 1 second, the transmitter is to be set up as HCS.
- Keeping buttons T1-T2 pressed, after approx. 20 seconds, the LED switches on fixed for ap-
prox. 3s. Releasing the buttons during these 3s, the transmitter is configured with the net ope-
rating mode (mode 3 blink >> 4 blink >> 2 blink >> 3 blink >> 4 blink >> etc).
If buttons T1/T2 are released when the LED is not on with the light fixed, no configuration
change is made.
*In this mode, the keys T1 and T3 are coded ARC and T2 and T4 are coded HCS.
HIDDEN BUTTON ACTIVATION
Some advanced features require pressing the “Hidden Key”.
In traditional transmitters, the hidden key is a button inside the container that must be pressed
with a paper clip or a piece of wire.
In new transmitters TO.GO/HAPPY/IRI.TX ARC, the “Hidden Key” can be accessed by pressing
the keys T1 and T2 simultaneously for at least 3 seconds.
When the LED flashes, it means that the “Hidden Key” code was sent.
Attention: If the LED flashes before 3 seconds, it means that the keys were not pressed simulta-
neously and you did not send the “Hidden Key” code
20 sec
3 sec
ADVANCED FUNCTIONS
>
>
>
>
T1
T2
T4
LED
T1
T2
T3
T4
3 sec
20 sec
T1
T2
T3
T4
To Next Page
Loading...
