Bennett T75 Operation, Service, & Parts Manual Parts
21
TYPE 75 PUMPING U NIT PARTS LIST
Refer to the Type 75 assembly on the previous page for reference number locations. Note: Not all parts are shown.
Uses (4) Item #2 for cover assembly
Seal, Square, OD=1 3/8”, ID=1 3/16 x 3/32
Clamping Ring, Rotor Cover
Cover, Control Valve Square Seal
Cover, Control Valve Square Seal
Seal-Square OD=2 5/8 ID=2 3/8 X 1/8
Original Cork Gasket Replacement Only! Note: Do not replace original
cork gasket with p/n 116697!
Cover – Adjustable Bypass Square Seal
Cover – Adjustable Bypass Square Seal
Gasket Adjustable Bypass Screw
Seal-Square OD=2 5/8 ID=2 3/8 X 1/8
Original Cork Gasket Replacement Only! Note: Do not replace original
cork gasket with p/n 116697!
Filter Cover Square Seal T75
Filter Cover Square Seal T75
Seal-Square OD=3.25 ID=3.00x.1250”
Original Cork Gasket Replacement Only! Note: Do not replace original
cork gasket with p/n 116697!
One Piece Air Separator Body
One Piece Air Separator Body
Also used with High Alcohol
Air Tube Separator Plastic
Tube Air Separator - Piston Brass
Tube – Air Separator End Cap
Atmospheric Float Assembly
Gasket, Meter Inlet Adaptor V1263
Cover, Atmospheric Chamber
Cover, Atmospheric Chamber
Meter Mount Style – High Alcohol
Cover, Atmospheric Chamber
Pipe Outlet with Motor Mount Ears
Cover, Atmospheric Chamber
Pipe Outlet with Motor Mount Ears – High Alcohol
Cover, Atmospheric Chamber
Cover, Atmospheric Chamber
Gasket – Atmospheric Cover