Bennett T75 Operation, Service, & Parts Manual Safety Information
4
GENERAL INFORMATIO N
Read this manual carefully and read all tags/labels attached to the T75 Pumping Unit before starting any maintenance and/or service. A pumping
unit that is not properly maintained will not perform properly and will void the Bennett limited warranty.
Before installation, operation, maintenance and/or service ensure that protection against lighting strikes are in accordance with the American
Petroleum Institute Recommended Practice RP 2003, Protection Against Ignitions Arising out of Static, Lightening, and Stray Currents.
Service of the Bennett products and all accessories (e.g. Nozzles, Hoses, and Breakaways) must be performed by a technician who is trained in
accordance to all codes, requirements, standards, and regulations.
HAZARDOUS LOCATIONS
For safe operation, ensure that the dispenser is in a classified area as detailed below per NFPA 30, Flammable and Combustible Liquids Code and
NFPA 70, National Electric Code. For further information on the classification of locations for Fuel Dispensers, see NFPA 30, Flammable and
Combustible Liquids Code.
CODES AND STANDAR DS
Follow all local, state, federal requirements, and accordance’s for installation of all equipment. Note: Refer to Appendices for approval
documentation.
ANSI/UL79 Power-Operated Pumps for Petroleum Dispensing Products
API 2003 – Protection Against Ignitions Arising Out of Stray, Lightning, and Stray Currents
International Fire Code – 2000 Edition
NFPA 30 – Flammable and Combustible Liquids Standard
NFPA 30A – Motor Fuel Dispensing Facilities and Repair Garages Standard
NFPA 70 – National Electric Code
OIML R117-1 Dynamic Measuring Systems For Liquids Other Than Water
PEI/RP100, Recommended Practices for Installation of Underground Liquid Storage Systems
PEI/RP200, Recommended Practices for Installation of Aboveground Liquid Storage Systems
UNAUTHORIZE D ALTERATION O F BENNETT PRODU CTS
DANGER: BEFORE PERFORMING ANY TYPE OF SERVICE TO THE DISPENSERS, BE SURE TO SHUT OFF ALL ELECTRICAL SUPPLIES AND
SECURE THEM IN THE OFF POSITION. CLOSE ALL VALVES IN INCOMING PIPING. MAINTENANCE MUST BE PERFORMED
BY TRAINED PERSONAL ONLY.
Bennett Pump Company products are designed to meet or exceed the standards of Underwriters Laboratories, Inc., Federal Communication
commission, and National Institute of Standards and Technology. Compliance with these standards protects the operator and the consumer from
personal injury and ensure an accurate delivery of product. Any deviation from the use of authorized replacement parts or alteration of a designed
product configuration may cause personal injury, death or the revocation of one or all of the above approvals.
Bennett Pump Company will not assume responsibility or liability for any consequential injury or damage caused by the unauthorized alteration of
its products.
ABBREVIATIONS AND ACRONYM S
To Next Page
Loading...