BenQ G2220HD - Page 35

- 35 -
Set luminance sensor mode to Dim C1 03 XX cksum
√
Increase ADC R-Offset2 AC 23 Data cksum
√
Increase ADC G-Offset2 AC 24 Data cksum
√
Increase ADC B-Offset2 AC 25 Data cksum
√
Increase ADC R-Gain AC 33 Data cksum
√
Increase ADC G-Gain AC 34 Data cksum
√
Increase ADC B-Gain AC 35 Data cksum
√
Decrease ADC R-Offset2 AD 23 Data cksum
√
Decrease ADC G-Offset2 AD 24 Data cksum
√
Decrease ADC B-Offset2 AD 25 Data cksum
√
Decrease ADC R-Gain AD 33 Data cksum
√
Decrease ADC G-Gain AD 34 Data cksum
√
Decrease ADC B-Gain AD 35 Data cksum
√
Read ADC R-Offset2 AE 23 XX cksum
√
Read ADC G-Offset2 AE 24 XX cksum
√
Read ADC B-Offset2 AE 25 XX cksum
√
Read ADC R-Gain AE 33 XX cksum
√
Read ADC G-Gain AE 34 XX cksum
√
Read ADC B-Gain AE 35 XX cksum
√
User mode to factory mode 1A 5A XX cksum
√
Auto Color (Offset1, Offset2, Gain) 1B 5A XX cksum
√
Copy EDID Serial number to EEPROM 1C 5A XX cksum
√
For specified “Industry
Customer” model.
Factory mode to User mode 1E 5A XX cksum
√
Clear user mode and factory recall 1F 5A XX cksum √
Store data to EEPROM
Write EDID data to MCU DDC RAM 55 NA NA NA
√
For MTV312 MCU type
Copy DDC RAM data to EEPROM BB NA NA NA
√
For MTV312 MCU type
Drive WP pin to low to enable write DDC
IC 55 NA NA NA √ For stand alone DDC IC
Drive WP pin to high to disenable write
function BB NA NA NA √ For stand alone DDC IC
Switch DDC bus to DVI-A DDC IC 44 NA NA NA
√
For input signal with
multi-input source
Switch DDC bus to DVI-D DDC IC 33 NA NA NA
√
For input signal with
multi-input source
Change Senseye Mode C0 0~3 XX cksum
√
Change Power Status D0 Data XX cksum √
PowerOFF: Data=AA
PowerON: Data=Other
Value
Change Language Type D1 Data XX ckssum √
Asia: Data=AA
European: Data=Other
Value