BenQ G2220HD - Operational Specification

- 6 -
Audio speakers supported No
Audio Jack (input connector) supported No
Earphone Jack (input connector)
supported No
Microphone function supported No
Mechanical Tilt base design Yes From -5 to +23 degree
VESA wall mounting design Yes
Mechanical Rotate design No
Mechanical Lift base design No
Kensington compatible lock design Yes
3.1.2 Operational Specification
3.1.2.1 Power supply
Item Condition Spec OK N.A Remark
Input Voltage range
Universal input full
range
90~264VAC /50~76Hz
√
Input Current range 90 ~ 264VAC < 1.5 Arms
√
Power Consumption Normal “On” operation <47 W
√
LED: Green
DPMS DPMS “Off” state < 1 W
√
LED: Amber
Inrush Current
110 VAC
220 VAC
< 30 A (peak)
< 60A (peak)
√
Cold-start
Earth Leakage Current 264 VAC/50Hz < 3.5 mA
√
Hi-Pot
1. 1500VAC, 1 sec
2. Ground test: 30A,
1sec
Without damage
< 0.1 ohm
√
(on-line test)
(in-lab test)
Power Line Transient IEC1000-4-4 1KV
√
IEC1000-4-5 (Surge)
Common: 2KV,
Differential: 1KV
√
CCFL operation range 90 ~ 264VAC 3~8mA
√
Depends on panel
source
CCFL Frequency 90 ~ 264VAC 40KHz ~ 80KHz
√
Depends on panel
source
Power cord
Color: Black
Length: 1500 +/- 50
mm
√
3.1.2.2 Signal interface
Item Condition Spec OK N.A Remark
15-pin D-Sub
Color: Black
Length: 1500 +/- 30
mm
√
Signal Cable
24-pin DVI-D
Color: Black
Length: 2000 +/- 50
mm
√
15-pin D-sub
connector
See Note-1
√
For 15-pin D-sub
Pin assignment
24-pin DVI-D
connector
See Note-2
√
For 24-pin DVI-D