The OSD (On-Screen Display) menu 37
Control
Setting
• RS-232C/LAN: Sets a terminal to control the display.
• IR Passthrough: Select it when multiple displays are connected via RS-232C
cables.
- Primary: Designate the display as the primary unit for remote control
operation. Only this display will be operated by the remote control.
- Secondary: Designate the display as the secondary unit. The display can
not be operated by the remote control, and will only receive the control
signal from the primary display via the RS-232 connection.
To go back to the default setting (RS-232C) for Control Setting, press INFO on the
remote control for 5 seconds.
Network
Settings
See Network connection on page 27 for details.
Set Monitor
ID
Assigns an ID number for the current display when multiple displays are
connected.
For use when under the RS-232C control mode.
HDMI
Control
Uses the HDMI CEC (Consumer Electronics Control) industry standard
protocol to share functionality between connected devices and the display. To
transfer system commands, you need to use an HDMI cable to connect the
display to a device equipped with HDMI CEC. Select On in this menu and you
can operate the main functionalities on your display and the connected device
with one remote control.
To Next Page
Loading...
