BenQ PointWrite PT20 - Configuration Setting

Configuration Setting16
Configuration Setting
1. PointWrite Mode:
• Pen Mode: Default selection
• Finger Touch Mode: Only available when PointWrite Module
works with BenQ PointWrite Touch module. When selecting
Finger Touch mode, pen and finger can be used simultaneously.
2. PointWrite Option:
• Ceiling Mount Mode: Click this item if you mount the projector on
the ceiling. When the projector is placed on the table, do not click
this item.
• Rear Screen Mode: If the projector is installed on the rear screen
system, click this item.
3. Resolution: Select Projector resolution.
4. PointWrite Alignment: See "Alignment View" on page 17.
5. PointWrite Calibration: See "PointWrite Calibration" on page 21.
6. PointWrite Language: The default language is the same as the
language for your operating system. If you want to change the language,
click on and then language list will display. After selecting
your preferred language, quit the PointWrite and start the
PointWrite again.
7. Information: Shows the camera firmware version.
Select Finger Touch Mode during the setting process.
1
2
7
3
6
4
5