What to do if my BenQ Digital projector has no picture?
If your BenQ Digital projector isn't displaying any picture, first ensure that the video source is powered on and correctly connected. Also, verify that the projector is properly connected to the input source device. Finally, make sure the correct input source is selected using the Source keys on the remote or the SOURCE button on the projector.
How to fix BenQ Digital projector that does not turn on?
If your BenQ Digital projector is not turning on, ensure the power cable is securely plugged into both the projector's AC inlet and a working power outlet, and that the outlet switch is on. If the projector was recently turned off, wait for the cooling process to complete before attempting to turn it on again. Also, check that the lamp cover is securely attached.
Why my BenQ Digital projector remote control does not work?
If the remote control for your BenQ Digital projector isn't working correctly, start by replacing both batteries with new ones. Ensure there are no obstructions between the remote and the projector. Also, make sure you're within 8 meters (26.2 feet) of the projector.
How to fix blurred picture on BenQ Digital projector?
If the picture from your BenQ Digital projector appears blurred, try adjusting the focus of the lens using the focus ring. If that doesn't resolve the issue, adjust the projection angle, direction, and height of the projector to properly align it with the screen.
What causes unstable image on BenQ Digital projector?
If the image from your BenQ Digital projector is unstable, ensure that the connection cables are securely connected to both the projector and the signal source. Connect the cables correctly to the appropriate terminals.
What to do if 3D content does not display correctly on BenQ Digital projector?
If 3D content is not displaying correctly on your BenQ Digital projector, first recharge the 3D glasses. Next, verify that the settings in the 3D menu are correctly configured. Ensure that you are using a 3D Blu-ray Disc. Finally, confirm that the correct input source is selected using the Source keys on the remote control or the SOURCE button on the projector.
General| Display Technology | DLP |
|---|---|
| Brightness | 2200 ANSI Lumens |
| Contrast Ratio | 10, 000:1 |
| 3D Ready | Yes |
| Zoom | 1.3x |
| Lens Shift | No |
| Native Resolution | 1920 x 1080 |
| Lamp Life | 3500 hours (Normal), 5000 hours (Eco) |
| Inputs | HDMI, VGA, Composite, USB |
| Throw Ratio | 1.15 - 1.5 |
To Next Page
