Bentone BG 550 - Page 87

87 Bentone
General
Press:
ESC
to return to parameter level.
Press
/reset
to save selected setting.
Press:
ESC
to return to parameter level.
P
V h min s %
Bild 96/0707
l
To the next parameter
P
V h
s
min %
Bild 100/0807
Parameter 542 to
activate the VSD / PWM fan.
You can choose:
0 = VSD / PWM fan OFF
1 = VSD / PWM fan ON
If the parameter is set correctly, move directly to the next parameter with
Press
/reset
to adjust parameter 542.
Select your setting by pressing one of the buttons
Press
/reset
to save the setting for parameter 542: VSD
Press:
ESC
to return to parameter level.
To the next parameter
Back to the previous parameter
!
This manual describes “1=gas modulating (Gmod)” type burners.
!
This manual describes “0=VSD
OFF” type burners.