bentrup TC507 - Page 24

24
This value is added to the corresponding process parameter before calculation. Can be used for example to
make selection of thermocouple dependant on temperature deviations
following parameters apply on selection MIN only:
15: value offset A
(value range -9999 to 9999)
16: value offset B
(value range -9999 to 9999)
17: value offset C
(value range -9999 to 9999)
18: value offset D
(value range -9999 to 9999)
This value is added to the corresponding process parameter before calculation. Can be used for example to
make selection of thermocouple dependant on temperature deviations
following parameters apply on selection MAX only:
25: value offset A
(value range -9999 to 9999)
26: value offset B
(value range -9999 to 9999)
27: value offset C
(value range -9999 to 9999)
28: value offset D
(value range -9999 to 9999)
This value is added to the corresponding process parameter before calculation. Can be used for example to
make selection of thermocouple dependant on temperature deviations
following parameters apply on selection SEL only:
35: output sel.A
(value range DO0.0 to DO1.0)
Sets the bit (digital output) to be used for the selection of the thermocouple. Can be used to change the
temperature sensor used for controlling automatically during programme run (e.g. using an EVENT)
36: output sel.B
(value range OFF, DO0.0 to DO1.0)
As before, but selects between options 0/1 and 2/3. Set to "OFF" if not used
.
.
#
©2015 bentrup Industriesteuerungen. We reserve the right to change specifications without prior notice.
Compiled
JUN 24
th
2015
Be