BENZING M1 – Fancier
OPERATION
30
HB_BENZING-M1_ZUECHTER-E_13.doc
GANTNER Pigeon Systems GmbH
[
TRAINING
]
[
START
] ................................ Start training race
[
STOP
] .................................. Finish training race
[
LIST
] .................................. List of training race (arrived and missing pigeons)
[
SPEED
] ................................ Calculation of speed of the pigeons
[
PIGEONS
]
[
LIST
] .................................. Registration list, bet list, pre-registration list, list of marked pigeons
[
DELETE
] .............................. Delete pigeons or registration
[
MARK
] .................................. Marking pigeons
[
CHANGE
] .............................. Change the colour and gender of pigeons
[
SYSTEM
]
[
Antenna
] ............................ Information on connected loft antennae, testing of the
antennae or rings respectively, update software of the
antennae
[
System Info
] ..................... Information on the device
[
Date / Time
] ..................... Setting date and time of the BENZING M1; only displayed if
no training or race is in progress
[
Display Contrast
] ............ Adjust the contrast of the display
[
Beeper Volume
] ................ Adjust the volume of the built-in beep
[
Fancier Name
] ................. Enter the name of the fancier
[
Language
] ........................... Select the language of the display
[
Printer
] ............................ Select the printer
[
Delete Season Map
] .............. Delete the season map
[
Default Amount
] ................ Turn on/off the automatic check of the nomination limit.
This menu item is only used in case betting on pigeons is
possible. This depends on the corresponding country and
club rules.
[
Online Print
] ................... Automatic printing via the BENZING Station
[
Sms Settings
] ................... Settings for sending SMS via a connected BENZING Station
[
Link STATION
] ................... Assigning the BENZING M1 to a certain BENZING Station.
This menu item is only displayed, if the BENZING M1 is
connected with a BENZING Station.
[
Master/Slave
] ................... Activation of the master function, in order to use an atis TOP
with master/slave software with the BENZING M1
To Next Page
Loading...
General