ice maker, be provided. Use receptacles that cannot be turned off by a switch or pull
chain. The fuse (or circuit breaker) size should be 15 amperes.
Recommended grounding method
For your personal safety, this appliance must be grounded. It is equipped with a power
supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-pronged and grounding-type wall receptacle,
grounded in accordance with the National Electrical Code and local codes and
ordinances. If a mating wall receptacle is not available, it is the personal responsibility of
the customer to have a properly grounded, 3-prong wall receptacle installed by a
qualified electrician.
Leveling the Ice Maker
Once the ice cube machine is set in its enclosure, if the base is not level, you can adjust
the feet by rotating the under block (see below) until the machine is level.
It is important for the ice maker to be leveled, or water may not flow properly through
the evaporator (ice mold). Ice production will be lower than normal, and operation will
be noisy.
Adjust the height of the under block of the adjustable foot, rotating it to the right
(counter- clockwise) to lower that side of the ice maker. Turning the under block to the
left (clockwise) raises that side of the ice maker.
Water Supply
The water supply should be ready at the point of installation. The water supply pressure
should be a minimum of 15 psig with a static pressure not more than 80 psig. (A wall
outlet directly behind the ice maker will make installation easier.)
We strongly recommended the use of a water filter. A filter, if it is of the proper type, can
remove taste and odors as well as particles and can prolong the life of the machine
.
IMPORTANT:
1. All installations must be in accordance with local plumbing code requirements.
Professional installation is recommended.
2. Water inlet fitting: 3/8” FPT (Female Pipe Thread); drain line connection: 1/2” FPT.
3. Make certain you have a suitable water supply hose and two suitable drain hoses,
and that the hoses are not pinched, kinked or damaged during installation.
Turning the under block
counter-clockwise reduces
the machine’s height
up
Turning the under block
clockwise increases the
machine’s height
To Next Page
Loading...
