minutes after the power has been turned ON, the ice maker will enter the cleaning mode.
If press the Clean button and hold it for more than six seconds, the machine will enter
the draining mode. The red, green and yellow LEDs will be blinking together.
Ice Size Adjustment Guide:
1. Press and hold the “Clean” button and the “Mode” button together for at least 3
seconds. The unit will enter the Ice Size Adjustment mode. The “ICE” LED (green)
will be blinking continuously during the ice size adjustment.
2. While in the Ice Size Adjustment mode, press the “Clean” button or the “Mode”
button for the desired ice size.
Smaller ice setting:
By pressing the “Clean” button, you can decrease the size of the ice cubes. The “FULL”
LED (red) will flash as you lower the ice size and will finally be blinking at the setting of
smallest ice size.
Larger ice setting:
By pressing the “Mode” button, you can increase the size of the ice cubes. The
“HARVEST” LED (yellow) will flash as the larger size is set and will blink when the
setting of largest ice size has been reached.
After 10 seconds without any operation, the unit will automatically memorize the current
state and return to the previous mode.
NOTE:
During the ice size adjustment, the “BIN FULL”, “HARVEST” and “ICE
MAKING” LEDS blinking all at once indicate that the unit is in the regular (middle)
setting of the ice size.
When the machine is in the cleaning stage or ice full stage, the ice size is not
available for adjusting.
INPORTANT:
• Avoid letting water contact the control box.
Troubleshooting
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this
manual first. If the problem persists, check the Troubleshooting Guide below and on the
following page. The problem may be something very simple that can be solved without a
service call.
To Next Page
Loading...
