4.3 Storage and Shipping
When equipment or insert cards are stored the fol-
lowing points have to be taken into consideration:
•
the maximum humidity (see Technical Data) is
not to be exceeded!
•
the storage temperature (see Technical data) is
not to be exceeded!
•
the stored parts have to be protected from dirt
and dust!
•
equipment and insert cards which
show the following symbol are obly
to be unpacked, stored or installed
in working areas which are electros-
tatically protected!
•
equipment and insert cards which have accumu-
lators should be connected to the mains at least
once a month!
•
the original packing has to be saved!
When equipment and insert cards are shipped, the
following points have to be taken into consideration:
•
equipment and insert cards should, if possible,
only be shipped in their original packing!
•
insert cards should be packed
without
batteries
or accumulators into covers which convey elec-
trostatic on both sides (if possible use the orig-
inal packing)!
•
insert cards should be packed with batteries or
accumulators into covers which convey electros-
tatic on the outside and anti-electrostatic on the
inside (if possible use the original packing)!
•
equipment or insert cards with the
following symbol should only be
packed in electrostatically protected
working areas!
Errors / Faults
WS5-5 Doc. no. 211.347/DGB 12.92 4 – 3
To Next Page
Loading...