Pitch bend pad adjustment
The pitch bend pads can be loosened using a screwdriver and slightly
shifted in distance from the thumb rest. Find the placement that makes most
sense to you and tighten the screws. Don’t over-tighten, as you could cause
damage to the conductive plastic of the pitch bend pads if you do. If the pad is
not moving or wiggling when pressed against from the thumb rest position, you
should be good to go.
Pinky key adjustment (NuRAD)
The pinky keys can be also be loosened using a screwdriver (Philips) and
rotated into favored positions. They can also be replaced with slightly longer or
shorter keys, thinner/wider ones or ”blind” keys if you want to remove a key that
you are not using. The keys are printed in conductive PLA plastic from a
parametric 3D model where these values can easily be altered for printing of
custom sized keys. The design file will be available for free on demand if you
want to print your own keys, or Berglund Instruments can supply these keys
already printed.
Battery check
When the main menu is activated, the battery voltage will be indicated top
right of the display. Values over 4.9V will indicate that the instrument is
powered over USB, and below that it will indicate it as battery voltage. Normal
voltage for a set of new alkaline batteries will be about 4.6V. The value will drop
as the batteries are being used, giving a hint of the current battery condition.
To Next Page
Loading...
Need help?
General