Patch selection
Pressing the ENTER button when the display is off will show the currently
selected patch number on the display for a couple of seconds. Pressing UP or
DOWN changes the patch number. You can hold the button pressed to get a
faster scrolling through the numbers. Pressing the UP or DOWN button when
the display is switched off will directly enter the patch view mode and step the
patch number up or down.
The patch number will be remembered by the controller even when
powered off. Holding ENTER button while powering up the NuEVI/NuRAD will
have it send a program change for the current patch selected.
FastPatch selection
You can store up to seven patch numbers that can be instantly recalled by
holding a combination of trill keys (NuEVI) or LH1, LH2 and LH3 keys (NuRAD)
when pressing any of the buttons ENTER, UP or DOWN from display sleep or
patch view state. (Just reach with your LH thumb without looking.) If no patch
number is stored for the selected memory slot, the selection will be ignored,
and the current patch number will be displayed.
To save a patch number into a memory slot, use UP and DOWN to select
the patch you want to store (no trill keys touched). From display sleep, finger
the key combination you want to use as memory slot, press and hold MENU,
then immediately press ENTER while still holding MENU. The display will briefly
indicate that the FastPatch has been set.
To Next Page
Loading...
Need help?
General