Legacy instant controls
The MIDI EVI was using fingering combinations to alter settings and send
patch change commands. For advanced users this can still be a desired thing,
so there’s support in the NuEVI for the most important parts.
Set this functionality on and off (default off) using the LEGACY PB setting in
the EXTRAS menu.
When the legacy instant controls are activated, you can instantly recall a
patch number by its respective MIDI note number. For example, by fingering
middle C (any transpositions set are not active here) while not playing, you are
selecting patch number 72. Touch both pitch bend pads at the same time to
send the patch change command for the patch number you are fingering. The
Teensy LED will flash once to confirm. Note that if that patch number is already
the patch known as active in the NuEVI/NuRAD, the command will not be sent.
To select patch numbers in the top and bottom end of the range 1 to 127, add
the pinky/MOD key to your fingering.
Using MIDI channel switching can be useful for switching between synths
or patches in performances. To instantly select a MIDI channel number, you can
finger it using middle C and upwards chromatically, where mid C represents
MIDI channel #1, touch the lip sensor with your lip, then touch both pitch bend
pads at the same time. The Teensy LED will flash once to confirm. Note that a
MIDI setting selected this way will not be remembered after powering off,
unless you go into the MIDI CH menu to confirm the change. This way, if you
have no idea why you suddenly can’t get a sound (because you accidentally
To Next Page
Loading...
Need help?
General