SETUP BR
Menu for settings related to breath control.
SETUP BR - BRTH CC A
Sets the MIDI CC to be sent to represent the breath data.
OFF – No breath CC data is sent.
MW – Breath data is sent as CC#1 (Mod Wheel)
BR – Breath data is sent as CC#2 (Breath, factory default)
VL – Breath data is sent as CC#7 (Volume)
EX – Breath data is sent as CC#11 (Expression)
MW+ – High res breath data is sent on CC#1 and CC#33 (Hi-res Mod Wheel)*
BR+ – High resolution breath data is sent on CC#2 and CC#34 (Hi-res Breath)*
VL+ – High resolution breath data is sent on CC#7 and CC#39 (Hi-res Volume)*
EX+ – High res breath data is sent on CC#11 and CC#43 (Hi-res Expression)*
CF – Breath data is sent as CC#74 (Filter Cutoff)
UNO – Breath data is sent as CC#20 (for use with IK Multimedia UNO Synth)
*) Hi-res MIDI is very often not supported in the receiving end, i.e. synths or
DAWs. It also uses more MIDI bandwidth. In most cases you are better off with
the regular CC signal. In cases where smoothing is not implemented in the
receiving end, Hi-res CC can be a way to get less stepping in the filter control.
As an example, the Minibrute gets stepping in the sound when the filter cutoff
is controlled with Aftertouch, but a smooth sound when the filter is controlled
by high resolution Modulation Wheel data.
To Next Page
Loading...
Need help?
General