SETUP BR – BRTHCC B
Secondary MIDI CC for breath data. Can be set to any CC between 1 and 127
and be used together with CC A or on its own with CC A set to OFF.
SETUP BR – CC B RISE
Multiplier to faster reach top value for CC B compared to CC A. For
example if you want to control amplifier (VCA) value with CC B and have it
reach full value at 25% of full breath, while CC A controls filter (VCF) cutoff in
normal fashion, set the CC B RISE to 4x.
1x – 10x (in steps of one)
SETUP BR - BREATH AT
Controls wether or not breath data should be sent as Aftertouch (Channel
Pressure).
OFF - No Aftertouch breath data is sent (factory default)
ON - Breath data is sent as Aftertouch.
SETUP BR - VELOCITY
Note velocity can be set to follow the initial breath value dynamically (DYN)
or to a fixed value (1 to 127). When fixed value is used, the velocity sample
delay is also bypassed for optimal timing of note on vs rising breath signal.
To Next Page
Loading...