Settings
To simplify configuration, the NuRAD and NuEVI have been equipped with
an OLED display and four navigation buttons. The middle buttons are MENU/
BACK (left) and ENTER (right), and the buttons above and below are the
buttons for UP and DOWN selection. When not used for configuration or patch
viewing, the display will be shut off to conserve power. Pressing MENU will
activate the display and the main menu. A flashing cursor will indicate items,
and ENTER will select the indicated item. Menu items directly controlling a
setting will trigger a square being shown on the right in the display, with the
adjustable value flashing inside it. Press UP and DOWN to select the desired
value and then press ENTER or MENU to select that value and store it in non-
volatile memory. The controller will remember this setting even if it is switched
off. To make a temporary change that will not be stored, leave the menu open
with the value flashing. After a while, the menu will shut off and the setting will
not be stored.
TRANSPOSE
This menu item allows you to transpose the instrument up or down twelve
semitones. Factory default transposition is C.
OCTAVE
This menu item changes the octave transposition of the instrument. Values
go from -3 to + 3, with +0 as factory default.
MIDI CH
This menu item selects the active MIDI channel, 1 through 16, for both DIN
MIDI and USB MIDI. Factory default is MIDI channel 1.
To Next Page
Loading...
Need help?
General