managed to switch to some other MIDI channel) a power cycle will get you back
in business.
Another way to trig the instant controls is to apply a gentle sucking
(negative air pressure) to the mouthpiece, while touching pitch bend up,
instead of touching both PB pads. To activate this functionality, go to LEGACY
BR setting in the EXTRAS menu. Using the sucking together with pitch bend
down, Nyle has added the legacy program button control (see below).
Yet another alternative way for patch number selection is to finger the
number like above, then lock it in by momentarily touching the pinky key. Send
mid range values by touching first valve and first trill keys at the same time, top
and bottom range values by touching second valve and second trill keys at the
same time.
Nyle’s program button functions
I have added the equivalent of the vintage MIDI EVI programming button.
It is activated by holding the down pitch bend and sucking. The legacy breath
activate feature must be on for this to work.
Implemented so far:
1. Middle octave position (c72). Ability to assign midi breath parameters, midi
volume, midi aftertouch, midi breath, midi expression and velocity.
1v - midi volume
2v - midi aftertouch
3v - midi breath controller
side button (4v) - midi expression
To Next Page
Loading...
Need help?
General