example, if a synth has a set pitch bend range of 12 semitones up and down,
setting the pitch bend divider to 1/12 will limit the range to just a semitone up
and down. The OFF setting will disable the pitch bend pads. Vibrato depth
follows the pitch bend divider setting. If the pitch bend pads are disabled, the
vibrato will still work at 1/1 range.
OFF – No pitch bend data is sent.
1/1 – Full pitch bend range. (factory default) 1/2 – Half pitch bend range.
..
1/12 - A twelfth of the pitch bend range.
ADJUST
Selecting this menu item enters the sensor adjustment screen. Here you
can monitor sensor reading values and change the threshold and maximum
(sensitivity) values for the sensors. Scroll through the various sensors using UP
and DOWN buttons and press ENTER to move the cursor to THR and MAX
items, where UP and DOWN buttons increase and decrease the values (the
indicator bar for the setting is moved right or left). Note that the MAX setting
can never be set lower than the THR setting. A moving pixel (SNS) indicates the
current sensor reading. Where several sensors are involved, a pixel for each
sensor will be shown. Also note that the intensive updating of the OLED display
while using the SETUP menu will interfere with the transmission of MIDI CC
data. For that reason, the ADJUST menu is to be used for setup only, not to be
activated during normal play. To perform an automatic calibration of any sensor
page, press enter to move the cursor to THR or MAX bar, then press up and
down buttons simultaneously. Make sure to keep fingers off the sensors when
doing this.
To Next Page
Loading...
Need help?
General