ADJUST - BREATH
THR level sets the amount of pressure needed to trigger a note and start
sending breath MIDI data. The breath indicator LED (blue) will light up when
pressure is over threshold. If the LED is always lit, even when you are not
blowing into the mouthpiece, you need to raise the THR setting until the LED
turns off.
MAX sets the pressure level that should correspond to full signal output.
This setting is of course to your individual preference, and with different
settings of the breath to signal transfer curve (SETUP BR - CURVE) you may want
to adjust this too.
ADJUST - LEVER
THR level sets the amount of forward thumb pressure on the lever needed
to start sending control data. The portamento indicator LED (red) will light up
when input is over threshold in case the lever is set up to control portamento. If
the LED is always lit, even when you are not actuating the lever, you need to
raise the THR setting until the LED turns off.
MAX sets the actuation level corresponding to full signal output.
ADJUST - TOUCH
THR sets the threshold for the keys and the octave rollers. When all keys
and rollers are untouched, the SNS dots should all be to the right of the THR
line. Keys touched one at a time, one of the dots should go left of the THR line.
This both verifies connectivity and correctly set THR level.
To Next Page
Loading...
Need help?
General