ADJUST - LIP/EC
The extra controller, activated in the SETUP CTR menu, is the lip or
embouchure sensor on top of the mouthpiece. It is a proportional touch
controller, working much in the same fashion as the pitch bend pads.
THR sets the threshold for the lip touch sensor. Make sure the SNS
indicator dot is to the left of the THR line when sensor is not touched.
MAX sets the lip touch corresponding to full controller signal output.
ADJUST - BEND
THR sets the threshold for the pitch bend touch pads. Make sure both of
the SNS indicator dots are to the left of the THR line, or you will have issues with
your pitch bend signal.
MAX sets the amount of finger pressure against pitch bend touch pads
required for full signal output. When adjusting this setting, move your thumb up
and down onto the pads to find a good setting. Note that what should be sent
as full pitch bend signal is controlled in the SETUP CTR - PITCH BEND menu.
The sensor MAX setting should always be set so the SNS reading is reaching
the MAX line when the pads are fully touched.
To Next Page
Loading...
Need help?
General