BERGLUND INSTRUMENTS NuEVI - Wireless Kit Channel Setup

To Next Page

To Previous Page

EXTRAS – WL CHANNEL

To set the radio channel of the midiBeam wireless transmitter, select a value

in this menu and press enter. Available values are 4-80. After changing this, the

transmitter and receiver will need to be paired again as the connection will be

lost. Note that this is just an “initial channel” that the midiBeam will use, during

pairing it will determine what the best channel is. The value is also not stored by

NuEVI, so the menu will always start at 4 (the default midiBeam channel).

Before changing any of the wireless settings, please read through the

midiBeam user guide describing these settings. This is available at http://

pandamidi.com/support.

NuEVI and NuRAD User Guide