EXTRAS – CV TUNE
Tuning of the CV output for 1V/Oct when using NuEVI CV, NuEVI Plus or
NuEVI/NuRAD with external CV box or module. Modules usually ship with a
suggested tuned value to enter here.
EXTRAS – CV SCALE
Scaling of the CV output for 1V/Oct when using NuEVI CV, NuEVI Plus or
NuEVI/NuRAD with external CV box or module. Modules usually ship with a
suggested tuned value to enter here.
EXTRAS – CV EC LFO
The CV EC LFO setting controls a CV LFO vibrato function for the extra
controller (lip sensor). It can be set to OFF (no extra controller LFO vibrato) or
values 1 through 8, which represent vibrato frequency from 4.5Hz to 8Hz.
Default value is 3 (5.5Hz).
EXTRAS – WL POWER
To set the radio power of the optional midiBeam wireless kit, select a value
in this menu and press enter. This should be done with the wireless receiver
linked up (steady glowing LEDs on TX and RX). The available values are 0, -6,
-12 and -18 dBm. 0 is the highest setting, and is the default setting in the
midiBeam. NuEVI does not store the setting (it is only kept in the midiBeam) so
the menu will always start on 0 when selected.
To Next Page
Loading...
Need help?
General