29 WWW.BERTIN-INSTRUMENTS.COM
Figure 18: Setting the marker
7.2.2 Set location ID
To associate different measurement locations a location ID between 0 and 31 can
be selected. The location ID is included in the read out data series. It can be
selected by using the Scroll up or Scroll down button and pushing the Enter button
for 2 sec.
Set location ID
11.08.16 12:27:47 4min
9
Enter a number indicating
the measurement location !
Use ↑↓ to change and
press <┘key to accept !
Figure 19: Setting the location ID
7.2.3 Set operation mode
This submenu allows the selection of the operation mode and the period of the
measuring cycle.
The diffusion mode with measuring cycles of 10 minutes and 60 minutes is available
with all types of AlphaGUARD.
The flow mode with measuring cycles of 1 minute and 10 minutes, as well as the
Radon/Thoron discrimination mode with a cycle time of 10 minutes, are available
with the AlphaGUARD DF2000.
To Next Page
Loading...