Bertin Technologies ALPHAGUARD DF2000 - Page 36

36 WWW.BERTIN-INSTRUMENTS.COM
USER MANUAL
Figure 30: Configure channel 1 or 2 - enter number of digits for decimal places
2. Enter the sensor’s measurement value corresponding to 0,0 V.
Configure channel 1
11.08.16 12:27:47 4min
+0.020
Enter the value
corresponding to 0.0V
Use ↑↓ to change and
press <┘key to accept !
Figure 31: Configure channel 1 or 2 - enter value corresponding to 0 V
3. Enter the sensor’s measurement value corresponding to 2,5 V.
Configure channel 1
11.08.16 12:27:47 4min
+5.400
Enter the value
corresponding to 0.0V
Use ↑↓ to change and
press <┘key to accept !
Figure 32: Configure channel 1 or 2 - enter value corresponding to 2,5 V
4. Enter the measurement unit of the sensor. Any unit can be implemented,
6 characters are available for the selection.
Figure 33: Configure channel 1 or 2 - enter the unit