LaserSpeed 8000/9000 I/O Module Instruction Handbook
Installation
Part No. 93342 / Drawing No. 0921-01516 Page 19 of 84 Revision E (Dec 2013)
Analog Outputs
Pins 32-37 of the SYSTEM STATUS port are used for various analog outputs.
Every I/O Module contains three analog outputs.
Elongation Analog Output – only used when using multiple I/O modules
are configured for Synchronization.
Velocity Analog Output
Quality Factor Analog Output
All analog outputs are non-isolated. You may set the scaling of the elongation
and speed outputs to fit your application. See the Serial Commands section.
To Next Page
Loading...