Beta LaserMike LASERSPEED 8000 - General Specifications

LaserSpeed 8000/9000 I/O Module Instruction Handbook
Specifications
Part No. 93342 / Drawing No. 0921-01516 Page 82 of 84 Revision E (Dec 2013)
General Specifications
Weight
6 lbs.; 13.2 kg
Input Voltage
100-240V, 50/60 Hz, 100VA.
Fuse
1.5A T 250V
Setup Connector
RS-232 not to exceed 10 meters in length.
DB-9 and DB-25 LaserSpeed Connectors
Cable length not to exceed 100 meters.
24Volts at 2 Amp fused supplied to gauge connector.
DB-9 Light Stack Connector
Cable length not to exceed 10 meters.
24volts at 0.2 Amp.
Analog Outputs
Voltage output range 0 to 2.048 V, RL = 10 k
Output load regulation accuracy VO = 2.048 V, RL= 2 k0.25 voltage % of FS
Ethernet Connection
RJ45, not to exceed 30 meters.
Profibus Connection
 Transmission media: Profibus bus line, type A or B specified in EN50170
 Topology: Master-Slave communication
 Fieldbus connectors: 9 pin female DSUB, as standard.
 Cable: Shielded copper cable, Twisted pair
 Isolation: The bus is galvanically separated from the other electronics
with an on board DC/DC converter. Bus signals (A-line and B-line) are
isolated via opto-couplers.
 Profibus-DP communication ASIC: SPC3 chip from Siemens.
 Fieldbus type: PROFIBUS-DP EN 50 170 (DIN 19245)