Beta RR 2T 2013 - Check the Front and Rear Brake Pads

3
CHECKS AND MAINTENANCE
39
GB
FRONT BRAKE LINING CONTROL
In order to verify the wear condition of front
brake is enough to view the plincer from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let’s start replacing them.
Note
Perform the check according to the times
shown in the table on page 55.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
REAR BRAKE LINING CONTROL
Inorder to verify the wear condition of rear
brake is enough to view the plincer from the
back side, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let’s start replacing them.
Note
Perform the check according to the times
shown in the table on page 55.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
2
2