3
CHECKS AND MAINTENANCE
40
GB
HYDRAULIC CLUTCH OIL LEVEL CHECK
To check the oil level in the clutch pump,
first remove cover 2.
Remove the two screws 1 and take off
cover 2 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
If necessary top up with (BARDAHL BRAKE
FLUID DOT 5.1) hydraulic oil, which is
available from your BETAMOTOR dealer.
BLEEDING THE HYDRAULIC CLUTCH
To bleed air from the rear clutch pump,
proceed as follows:
•Open the sump cap.
•Insert one end of a trasparent tube into
a container.
•Pump with the clutch lever 2/3 times and
keep the lever pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
aperation until obtaining a continuous
outflow of oil within no air bubles.
•Close the valve and release the lever.
NOTE:
The pump is suitable for bleeding in depres-
sion. During this procedure, continuosly top
uo the clutch pump thank to replace the oil
that is out flowing.
•Remove the tube.
2
1
3
To Next Page
Loading...
