l Lightly press the BIND button on the back of the remote control radio transmitter with
a screwdriver. The power indicator will flash red;
l If re-bind is successful, quadcopter status light will change to blue.
Note: The re-binding of the remote control radio transmitter and the quadcopter may not be
successful after pressing the BIND button of the remote control radio transmitter once. In this
situation, pilot needs to press the BIND button a second time to complete the binding.
Quadcopter Level Calibration
After the quadcopter has taken off and landed several times, the quadcopter gyroscope may
become offset. This will cause the quadcopter to always tilt in the same direction during a flight.
To fix up it, the quadcopter gyroscope can be recalibrated. The steps are as follows:
l Turn on the quadcopter and the remote control radio transmitter, and ensure that the
connection is successful;
l Place the quadcopter on a horizontal plane;
l Enter the quadcopter’s OSD menu (Refer “OSD Menu Operation”);
To Next Page
Loading...
Need help?
General
