Better BT0323 - Troubleshooting

20
Troubleshooting
Ifyoususpectsomethingiswrong,immediately
switchpoweroff.Immediatelystopusingitand
callthestorewhereyoupurchasedit.
Nevertrytorepairtheunityourselfbecauseit
is dangerous to do so.
General
No power or no sound.
Car'sengineswitchisnoton.
Turn your car's key to ACC or ON.
Cable is not correctly connected.
Check connection.
Fuseisblown.
Replace fuse.
Check volume or mute on / off.
Iftheabovesolutionscannothelp.
Press the RESET button.
Disc
Disc is inside but no sound.
Discisupsidedown.
Place disc in the correct direction, and the
label side up.
Disc is dirty or damaged.
Clean disc or change another disc.
Disc sound skips, tone quality is
low.
Disc is dirty or damaged.
Clean CD or change another CD.
Sound skips due to vibration.
Mountingangleisover30
o
.
Adjust mounting angle to less than 30
o
.
Unstable mounting.
Mount the unit securely with the mounting
parts.
Radio
Noise in broadcasts.
Stationistoofar,orsignalsaretooweak.
Select other stations of higher signal level.
Preset station lost.
Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
Error display messages
Display shows ERROR.
Discisdirty,damagedorupsidedown.
Press
to eject the disc.
When video le initializing time is
too long.
Filereaderrororletypenotsupported.
Press SRC to exit. Then press SRC to play
disc again.