- 10 -
7 Deactivation function
The ninth code may be used as a “deactivation” code, by which
Codoor may be set manually in the unlocked position. Follow
these steps:
1. Press then enter code 9 (4 digits). Finish
by pressing .
2. The red LED will flash slowly, accompanied
by simultaneous sounding of the buzzer.
3. Press 1 . The green LED will come on. The
buzzer sounds a rising tone to confirm the code
has been entered.
4. After 4 seconds the lock will open. It will then open
automatically each time the door handle is used.
Codoor will remain unlocked until reset to the
locked position.
Note! If the Codoor fails to open the lock (i.e. the handle is held own), it will
attempt to open the lock 10 times. It will try a further 10 times if a button is
pressed at least 10 seconds after Codoor has tried unsuccessfully to unlock
the door.
Return to locked position
1. Press then enter code 9 (4 digits). Finish
by pressing .
2. Enter 0 . The green LED will come on.
The buzzer sounds a rising tone to confirm
the code has been entered.
3. Press the door handle down once to relock
the door.
Of course, code 9 works as a normal code if is not entered before and after
the code. You can disconnect the deactivation function by following these
steps:
Continued on next page.
To Next Page
Loading...