- 11 -
Continued from previous page.
1. Press , and then enter the 6-digit
programming code. Finish by pressing .
2. The red LED will flash slowly, accompanied by
simultaneous sounding of the buzzer.
3. Enter 68 . The red LED will flash faster..
4. Enter 0 . The green LED will come on.
5. Exit programming mode by entering 00 .
The buzzer sounds a rising tone to confirm.
If you want to reconnect the deactivation function, repeat steps 1
to 5, but enter 1 instead of 0 in step 4.
8 Buzzer
In operating mode, Codoor’s buzzer may be programmed to
sound as each key is pressed, or to remain silent. At delivery, the
buzzer is programmed to sound. However, if silent operation is
required, proceed as follows:
1. Press , then enter the 6-digit programming
code. Finish by pressing .
2. The red LED will flash slowly, accompanied
by simultaneous sounding of the buzzer.
3. Enter 65 . The red LED will flash faster.
4. Enter 0 . The green LED will come on.
5. Exit programming mode by entering 00 .
The buzzer sounds a rising tone to confirm.
If you wish to reactivate the buzzer, follow steps 1 to 5, but
press 1 instead of 0 in step 4.
6 8
To Next Page
Loading...