Beyerdynamic QUINTA Series - I Command - Chairman Priority Message

44 Conference Control Commands
4.7 l command
Chairman priority message
The l 00 resp. l 01 message is received by the CU each time a chairman has pressed the
func button.
Depending on the priority mode different things are added to the l 00 message:
First the priority mode is displayed. Then it is added whether the function button is now
activated or deactivated. This is only the case if the function button can remain
activated for a longer period of time. If it remains activated only as long as it is pressed
(mode 3, 7 and 8), this is not displayed; however, in mode 7 and 8 the set message which
is sent when pressing the button will be displayed.
Please note the protocol listed under examples for the exact procedure in the different
priority modes.
Communication direction
MU -> CU -> Controller
Syntax
Description
l 00
Received from CU
after a chairma
[priority modes 1 to 8 (short keystroke)]
l 01
Received from CU
after a chairma
[priority mode 8 (long keystroke)]
Clear all MUs in speaking or speak request mode
(combination of the commands from chapter 4.5 and 4.6)
Transmit:
i 00<CR>
~Q 00<CR>
~Q 10<CR>
Receive:
<CR><LF>
>
Q messages and q messages if there were open microphones