Bezzera Matrix Series - Switching Water Source Modes

51
MOD. BEZZERA MATRIX-DUO
3) Scroll the menu with the side arrows until reach-
ing "sensor" and touch the relevant icon.
4) Make sure that the tank is empty, dry and cor-
rectly inserted in its seat.
5) Press OK and wait.
6) Once finished fill the tank to start using the ma-
chine.
5.13 Water source selection
Although Matrix and Duo are provided pre-set
for tank mode, it is possible to easily switch to
mains mode and vice-versa at any time (see sec-
tion 4.2.3).
To change water source proceed as follows:
1) Open the drop-down menu.
2) Access the settings screen by entering the
password (if any).
1
2
3) Scroll through the menu with the side arrows
until reaching "water inlet"”.
4) Click on the mains or tank icon; a green line
will indicate which of the two modes is ac-
tive.
5) Exit the menu by tapping OK.
It is not necessary to switch the machine off and
on again to apply the change.