BGates LT - SMS Command Functions (Part 3); Check Device Status; Pulse Mode Settings; Bistable Mode Settings

10
Changing the response SMS text
to command 4 “Check Number”
(for an enabled number)
password,E,T3,new text
ex. 1234,E,T3,number in phonebook
Default SMS:
“found in phonebook”
(max 160 characters)
11
Changing the response SMS text
to command 4 “Check Number”
(for an number not enabled)
password,E,T4,new text
ex. 1234,E,T4,number not in phonebook
Default SMS:
“not found in phonebook”
(max 160 characters)
12
COMPLETELY deleting the numbers
saved in BGates LT
password,E,DELETE WARNING: this command deletes all of
the numbers saved in BGates LT
13
Check the status of the BGates LT
device (status, rmware, antenna)
password,E,PING You will receive a response SMS with
the status of the BGates LT device, the
rmware version and the level of antenna
signal strength (ex. LT Running, rmware
x.y.z, signal 20.0)
14
Pulse operating mode settings
1
(factory value)
password,E,M,1 Pulse mode
15
Bistable operating mode settings
1
password,E,M,2 Bistable mode
17