BIANCHI VENDING SOFIA ESPRESSO - Connection and Initial Startup; Water and Electrical Connections; Initial Machine Flushing and Warm-up

12
Level display (5) indicates the level of the water in the boiler.
The Soa Espresso coffee machine series have been equip-
ped with a device that automatically keeps the water level
in the boiler constant, by acting on the pump and on the
electrovalve. If said level were not visible, switch the ma-
chine off and contact the sales service network.
Display (3) [only for Automatic models that are equipped with
one]
The multifunction display that the machine is provided with pro-
vides useful indications to the user on the machine operation
status:
··Uponmachinestart-upandduringpossibleboilerll-upope
-
rations,thedisplayunitdisplaysthe“boilerll-up”message.
· During the machine’s standby mode the display will show up
the “select drink” message followed by another, customised
message entered by the user.
· During the dosage programming phase, the display will show
up the operations being run by the machine (section 8 refers)
Key 14 dispenses the dose necessary for the preparation of one
single espresso coffee
Key 15 dispenses the dose necessary for the preparation of two
espresso coffees
Key 16 dispenses the dose necessary for the preparation of one
single further diluted (i.e. weaker) espresso coffee
Key 17 dispenses the dose necessary for the preparation of two
further diluted (i.e. weaker) espresso coffees
Key 18 activates continuous dispensing. Pressing the key for a
second time, dispensing is interrupted.
6.2 Avvio macchina
· After having run another examination of the electric and hydrau-
lic system connections, open the hydraulic system inlet tap.
· Position selector switch (11) on rst position and wait until
the electronic power pack that the machine is equipped with,
executes the necessary control runs and activates the pump
andelectrovalveforboilerll-up
If the boiler is already at full level, the automatic level
control will prevent the pump from starting up again
· Via the appropriate level display (5) check that the boiler is at
full level and that the pump is on standby.
· Semi-Automatic dispensing version:
 Positiontheemptylterbasketintothedispensinggroup,then
press pushbutton (12) and wait for the water to run out of the
lterbasketspout.Pressthepushbuttononceagaintoendthe
water dispensing cycle.
· Automatic dispensing version:
 Positiontheemptylterbasketintothedispensinggroup,then
presspushbuttonandwaitforthewatertorunoutofthelter
basket spout. Press the pushbutton once again to end the water
dispensing cycle.
· Position selector switch (11) onto position 2, the signal light
(13) on the side will light up and the heating element will begin
the heat-up phase of the water in the boiler.
· Wait for the red signal light (13) to go off, meaning that the
ideal pressure in the boiler has been reached.
During machine operations the red signal light will go on
and off at irregular intervals, depending on machine use.
· When the red signal light (13) goes off, it means that the heating
element is off as well.
Semi-Automatic dispensing version:
· Positionthelterbasketlledwiththegroundcoffeeintothe
dispensing unit.
· The cup/cups under the dispensing spout
· Press the coffee dispensing pushbutton (12) that is located in
the foreground
· Once the required quantity of coffee has been dispensed into
the cup, press the coffee dispensing pushbutton (12) again to
stop dispensing.
Automatic dispensing version:
· Positionthelterbasketlledwiththegroundcoffeeintothe
dispensing unit.
· The cup/cups under the dispensing spout
· Press key (14) for the coffee to be dispensed in one single cup.
The coffee dispensing cycle will end automatically
· Press key (15) for two espresso coffees to be dispensed. The
coffee dispensing cycle will end automatically
· Press key (16) for the dispensing of one further diluted (i.e.
weaker) espresso coffee, in one single cup. The coffee dispen-
sing cycle will end automatically
· Press key (17) for the dispensing of two further diluted (i.e.
weaker) espresso coffee, into two cups. The coffee dispensing
cycle will end automatically
· Press key (18) for the continuous coffee dispensing mode.
Key 12 coffee dispensing pushbutton
Multifunction keypad (only for the Automatic versions)
Pushbutton dispensing version control-pushbutton.