MANUAL INSTALLATION
Version: 1.0 (22-09-2005) 29
8. Only units that can cool:
- Set the desired room temperature to a low value (see
section
4.3).
- Feel if the discharged air gets cold. This may take some
time. You may want to read the actual discharge tem
-
perature from the service menu (section 8.2) – only for
CC M, parameters 36 and 37.
9. Only units that can both heat and cool:
- Check if the position of the angle adjustment ring
changes when switching from heating to cooling. This
may take some time for CC M units.
10. Only ventilation units:
- Check the operation of the air valve servomotors.
To Next Page
Loading...