8
Wiring
cover
Step 8. Installing the wiring cover
Slide the wiring cover into position, allowing about a 1/8” (3 mm) gap to the ceiling. Rotate the wiring
cover so that the mounting slots align with the screw holes. Secure the wiring cover screws on both
sides of the extension tube to hold the cover in position. Make sure that there are no wires visible.
Slide the wiring cover trim up the extension tube, aligning the tabs on the inside of the ring with the
slots on the bottom of the wiring cover. Twist clockwise to snap the wiring cover trim into position as
shown.
If there is not enough clearance between the wiring cover and ceiling, the screw can be moved to the lower
hole on the extension tube.
Step 7. Wiring the fan
With the fan hanging from the safety cable, connect the fan wires to the ceiling wires by twisting
the ends together and securing them with wire nuts. Refer to the chart and wiring diagram on the
following page to determine the wire connections. Test the connection by tugging on the wire nuts.
Install the fan on a switched circuit so that you can turn o the fan using a wall switch in addition to using the
remote control.
For extra space when wiring the fan, carefully remove the mounting hardware and allow the fan to hang from
the safety cable. This also ensures there is enough slack in the wires.
tip!
Wiring
cover trim
Electrical
tip!
CAUTION: Disconnect power to the fan location before wiring the fan!
To Next Page
Loading...
Need help?
General
