Bigab 7-10 - Page 15

      G  G
www.forsmw.com
15
Table 1. Example of weight of dierent types of load
Load, kg Kg/m³ Full container 7 m³ 14 m³ 21 m³ 27 m³
Peas, Wheat, water content 15% 800 5.600 kg 11.200 16.800 21.600
Rye, water content 15% 750 5.250 kg 10.500 15.750 20.250
Barley, water content 15% 680 4.760 kg 9.520 14.280 18.360
Oats, water content 15% 560 3.920 kg 7.840 11.760 15.120
Silage, newly harvested 850 5.950 kg 11.900 17.850 22.950
Macadam 1 400 9.800 kg 19.600 29.400 37.800
Gravel 1 550 10.850 kg 21.700 32.550 41.850
Clay 1 800 12.600 kg 25.200 37.800 48.600
Wood chips (50% moisture content) 350 2.450 kg 4.900 7.350 9.450
*The higher the moisture content of the load, the heavier the load, a fact that the user has to take into consideration.
This table is only an approximate estimate of the weights that can occur, and it is the responsibility of the user to ensure
that the vehicle’s limits and the applicable legislation are not being exceeded. The specied values are not exact values,
just examples.
For information purposes and for examples of how the weight of dierent loads may vary, please refer
to the above table. This table should only be viewed as guidance and information. The manufacturer
cannot be held responsible for dimensions or volumes specied in the table, and the table may only be
viewed as a recommendation.
Changing operating function
Figure below shows the lever for manually changing between the operating functions. The lever is
located on the left side of the chassis. This operating function is also available with hydraulic drive.
Changing operating function
NOTE! The bolt needs to be locked within the handles extreme position.
NOTE! It is not allowed to change the changing unit unless the frame is in locked position.