Bigab 7-10 - Lubrication Schedule

      G  G
www.forsmw.com
25
LUBRICATION SCHEDULE
Recommended lubrication cycle is once per week or after 20 working hours. Lubricate points equipped
with grease nipples by using a grease gun. Use recommended lubricants.
• Ensure regularity of lubrication by following the lubricating schedule.
• Keep ammable material away from heat, sparks and open re.
• Do not allow oil to spill on the ground as it will cause environmental pollution.
Figure 1. Lubrication points of BIGAB
* 4 pcs for tandem suspension, 8 pcs for mechanical pendulum bogie,12 pcs for sprung pendulum bogie
**Only for tandem suspension
***Only for mechanical pendulum bogie
Suspension bearings, 6 pc **
Bogie bearings, 2 pc ***
Roller bearings, 2 pc
Back frame bearings, 2 pc
Brake link bearings*
Front frame bearings, 2 pc
Main cylinder bearings, 2 pc
Handbrake bearings, 4pc
Frame lock cylinder bearing, 1pc
Steerable drawbar bearings, 6 pc (optional)