Bigab 7-10 - Clearing Blockages and Cleaning; Transport; Maintenance

      G  G
www.forsmw.com
17
CLEARING BLOCKAGES AND CLEANING
• When cleaning, rst perform a rough cleanse using just water. Avoid using high-pressure sprays
on electrical components;
• Use an environmentally friendly detergent. Allow it to work for the specied time. Rinse o with
hot water;
• Always lubricate the BIGAB after cleaning.
TRANSPORT
The hooklift trailer is meant to be transported attached to the tractor at maximum design speed.
• Ensure that none of the additional equipment connected to the trailer can cause accidents
during transport;
• You must always maintain control of the unit in all situations;
• Always check that the LGV sign and reective signs are in the correct locations;
• The permitted transport dimensions, must never be exceeded;
• Before driving, check that no one is in the vicinity of the machine and that your visibility is
unrestricted;
• Bear in mind the height of the machine when driving under yovers;
• Trac rules are there to be followed - comply with the applicable legislation.
NOTE: Observe the specied safety distance to electrical cables when you are in the vicinity of such
cables.
MAINTENANCE
• Make sure that the trailer is standing on a at surface;
• Make sure that the trailer can’t move;
• When lubricating or servicing the trailer, turn o the vehicle engine;
• Be sure that the trailer can’t slip when using support leg, jack or similar equipment;
• Always use the security post in tipping position when servicing. The security post must
always be used when carrying out service work in the tipped position. There must not be
any load on the trailer when carrying out service work in the tipped position (see gures
below);
• Never attempt to do maintenance work on the hydraulic system before you are sure there
is no pressure;
• Do not tighten or repair leaking hydraulic couplings while the system is pressurized;